A resistor limits current and dissipates electrical energy as heat. The voltage drop depends on both resistance and the current through it.
1. Set up the experiment
Sweep resistance from low to high with a fixed supply. Compare current, power and fan speed in the ideal load model.
2. Connect the result to the equation
V = IR; P = I²R
Change one parameter at a time and keep the others fixed. Read the signed output and current, then use the curve to distinguish a steady relationship from a changing transient.
Initial supply
3.00 V
Initial current
1363.636 mA
Initial output
3.000 V
3. Notice the limits
Resistance is not a fixed amount of current removed from a wire. It sets the relation between voltage and current across its terminals.
Circuit reference diagram
Continue this learning path
About the Electronics 101 Simulation
Are these circuit simulations exact?
They are analytic teaching models: ideal sources and switches, fixed diode drops, simple BJT gain and saturation, exponential RC behavior, and illustrative sensor curves. They are not a SPICE solver or construction verification.
Do I need hardware or a login?
No hardware or account is needed. The 3D view needs WebGL, while diagrams, controls and static lessons remain available as alternatives. Progress is stored in this browser and can be exported.
Which current direction is shown?
Moving markers represent conventional current, not electron drift. Their motion is illustrative and is not a measurement of charge velocity.
Model references and scope
These lessons use standard lumped-circuit relationships and explicitly simplified component models. Diagrams explain teaching topologies, while the breadboard probe explains socket continuity. The workbench is not a verified physical assembly plan.